WARNING: DO NOT USE A TRIPOD WITHOUT A QUICK-RELEASE PLATE! THE QUICK RELEASE PLATE (PHOTO BELOW) ALWAYS HAS TO BE ATTACHED FIRST
Attach the tripod quick release plate to the underside of the cube.
Slide it as far towards the back of the cube as possible before tightening the screw.
This gives maximum clearance to the fan air intake, and optimises center of balance when the cube is tilted upwards
Mount the quick release plate into the quick release clamp (A) and tighten screw (B) to secure the cube to the tripod ball head.
Tilt Lever (C) tightens and loosens the ball, allowing the cube to be tilted left, right, forwards or backwards.
Pan Lever (D) tightens and loosens the rotation mechanism allowing the cube to be rotated left or right.
To lower the safety beam stop (F), slightly loosen each of the beam stop screws (E)