Pending product launch, the network capability is not visible immediately after LaserOS install.
To activate network capability, go to Settings, General and select Debug.
Selecting Debug will open a text box. In the text box, type testwifi, then OK.
A new button “Network” will appear at the top of the Settings, General page.
With the network switch off, LaserOS uses USB mode and cannot detect network cubes.
With the network switch on, LaserOS uses network and cannot detect USB cubes.
Having enabled Network in LaserOS, and connected to the LaserCube over WiFi or LAN - see connection modes, the grey No Laser status indication will become Laser OFF.
Clicking Laser OFF will enable the Laser output and the text will change to Laser ON.Once your LaserCube is set up and connected, power it on with the power switch. Depending on your setup, your control device (Windows, Mac, or Android) may auto-detect the LaserCube and start LaserOS automatically. If LaserOS does not start automatically, start it by double clicking on the app icon (Windows or Mac) or taping on the app icon (Android).