At the first power on, the LaserCube will be in WiFi Server Mode.
Make sure the interlock plug is installed and then cycle the key-switch from Red to Green.
The two emission warning LEDs should come on.
A short press of the Mode Button will cause the Cube to use its laser to project the Firmware Version (if at 0.6 or above), followed by “WIFI SERVER” then “GWIP:192.168.1.1”
It will also create a 2.4GHz wireless network with the AP name “LaserCube”
The Status LED will flash Cyan, showing that the WiFi server is waiting for connection.
Connect to this wireless network (your OS may advise that this network has no internet connection, so you may have to select an option to stay connected to it).
The WiFi password is Laser2020 - Note, the password is case sensitive.
Once connected, the Status LED should remain Cyan, and stop flashing.
If the firmware version was not projected before the WIFI SERVER text, update the firmware.